Your reliable source of Mastercam Post Processors
Not a Mastercam user and need a post for a different CAM system? Contact us and we’ll connect you with one of our partners.
As a authorized reseller of CIMCO we are proud to offer CIMCO Post Processors for Mastercam. You can and should expect prompt friendly service for all your post processor and CIMCO software needs from Managed Solutions. CIMCO Integration has extensive experience providing post processors for lathes, 3, 5 or 6 axis mills and virtually any type of axis setup including both axes in the head, axes in the head and table or both axes in the table. Supported machine types include Deckel/Maho, Hermle, Reichenbacher, Hüllhorst, Fadal, Geiss, Zimmermann, Okuma, Maka, CMS, Hurco, Ferrari, Willemin, CME, Bacci, Bulleri, Mazak, Mori Seiki, FANUC, Andron, HAAS, MAG Fadal, DMG and more. We will provide you a demo post processor for your machine, and if you are not satisfied we’ll make it work the way you need it. There is zero risk to you when purchasing a post processor from Managed Solutions.
Already know what you’re looking for? Jump to get a quote call us at (925) 272-0384 or read on for more information.
Custom Post Processors
Even if a off the shelf post processor is not available for your machine CIMCO is able to custom build 5 to 6 axis post processors for most machine configurations. Additionally the post processors we offer can be further configured by the end customer and CIMCO Integration can provide further documentation and other guidance if necessary.
Enchanced Mastercam Post Processor Capabilities
CIMCO post processors for Mastercam include a long list of advanced features which makes them both efficient and a good choice for customers. Some of these include: Fully configurable post processor, for any type of axis setup (both axes in the head, axes in the head and the table, or both axes in the table). Feedrate control for accurate surface feed, rather than feedrate applied to the axes. Provides tilted and swarfed machining, not only on curves, but also on surfaces. Creates intermediate coordinates if the axis rotations are too large, applying linear and polynomial interpolation. Supports all 5-axis toolpath types; Curve5ax, Drill5ax, Swarf5ax, Flow5ax, and 5-axis ruled.
Additional Special Features
The post processor will start at a rotational angle (typically in the C axis), from where you will be able to do all the machining without any retracts, if possible. However, if this is not possible, because the moves are beyond the machine limits, the post processor will retract the tool in the tool direction, rewind the C axis and reposition,and then continue automatically. This is very important for machines with a robot head setup such as e.g.Gantry machines.
If you have a surface with bumps or curves which is not 100% smooth, most post processors will output codes, where you will have large rotational angles whenever the tool angle is almost vertical. This problem is eliminated with this post processor.
The post processor will start at the tilt side where you can do all the machining without any retracts, if possible. However, if this is not possible, the post processor will retract and continue on the other side.
All user variable settings can be specified in the post processor parameter file and only the parameters needed by the customer are active.
Ordering your Mastercam Post Processor
For your convenience we’ve provided a simple form below that you can use to request an estimate for a Post Processor that will meet your needs. Just fill out this form as completely as possible and we will contact you with an estimated cost for your post processor, as well as a demo post if available. Most orders can be filled quickly, within 24 to 48 hours.